Table of Contents
1 Meaning of symbols 9
2 Security 10
2.1 Target group 10
2.2 General safety instructions 10
2.2.1 General information 10
2.2.2 Transport 11
2.2.3 Setup 11
2.2.4 Operation 11
2.2.5 Service and maintenance 11
2.3 Meaning of written warning notices and hazard symbols 12
2.3.1 Warning notices 12
2.3.2 Hazard symbols 12
3 Directives and standards 13
3.1 EU directives 13
3.2 Overview of Conformity to EN50131 Standard 13
3.3 Compliance with VdS 2115:2015-12 18
3.3.1 Compliance with EN50131 Approvals 18
3.4 Compliance with EN 50136-1:2012 and EN 50136-2:2014 19
3.5 Compliance with INCERT Approvals 19
3.6 Compliance with NF and A2P approvals including CYBER requirements - SPC Products 20
4 Technical Data 21
4.1 SPC Matrix 21
5 Introduction 22
6 Mounting system equipment 23
6.1 Mounting a G2 housing 23
6.2 Mounting a G3 housing 23
6.2.1 Mounting a Back Tamper Kit 24
6.2.2 Battery installation for EN50131 compliance 27
6.3 Mounting a keypad 28
6.4 Mounting an expander 28
6.5 Wiring the X-BUS Interface 28
6.5.1 Wiring the Inputs 29
6.5.2 Wiring the Outputs 30
7 Controller hardware 31
7.1 Controller Hardware SPC42/SPC52/SPC53/SPC63 31
8 Door Expander 34
9 Wiring the system 35
© Vanderbilt 2023 3 I-200572
08.12.2023
To Next Page