Acre SPC42 - Page 4

9.1 Wiring the X-BUS interface 35
9.1.1 Loop configuration 36
9.1.2 Spur configuration 37
9.1.3 Star and multi-drop configuration 38
9.1.4 Shielding 43
9.1.5 Cable Map 43
9.2 Wiring of branch expander 43
9.3 Wiring the system ground 44
9.4 Wiring the relay output 44
9.5 Wiring the zone inputs 45
9.6 Wiring an external SAB bell 48
9.7 Wiring an internal sounder 48
9.8 Wiring Glassbreak 49
9.9 Installing plug-in modules 49
10 Powering up the SPC controller 51
10.1 Powering from battery only 51
11 Keypad user interface 52
11.1 SPCK420/421 52
11.1.1 About the LCDkeypad 52
11.1.2 Using the LCD keypad interface 54
11.1.3 Data entry on the LCD keypad 57
12 Starting the system 59
12.1 Engineer modes 59
12.1.1 Engineer PINs 59
12.2 Programming with the keypad 59
12.3 Configuring start-up settings 60
12.4 Creating system users 61
12.5 Programming the portable PACE 62
12.6 Configuring wireless fob devices 63
12.6.1 Clearing alerts using the fob 63
13 Soft Engineer programming via the keypad 65
14 Engineer programming via the keypad 66
14.1 System Status 66
14.2 Options 67
14.3 Timers 71
14.4 Areas 75
14.5 Area Groups 77
14.6 X-BUS 77
14.6.1 X-BUS Addressing 77
SPC42/52/53/63 – Installation & Configuration Manual Table of Contents
© Vanderbilt 2023 4 I-200572
08.12.2023