Acre SPC42 - Panel Status; Status; X-Bus Status

Message Description
Authorization
error
User name and/or password are incorrect
Unknown An unknown error was returned. The camera may be an unsupported model.
15.6 Panel status
This section covers:
15.6.1 Status 127
15.6.2 X-Bus Status 127
15.6.3 Wireless 132
15.6.4 Zones 134
15.6.5 Doors 135
15.6.6 FlexC Status 136
15.6.7 System alerts 137
15.6.1 Status
This page displays the status and summary of the main SPC components, including system, power, X-
BUS and communications.
1. Select Status > Hardware > Controller Status.
See following sections for further information.
Performable actions
The following actions are only possible if a connection has been established.
Restore All Alerts Restores all active alerts on the panel. These alerts messages are displayed in
red text opposite the relevant item.
Refresh Updates any changes in panel status. You must refresh the status page to
display the actual panel status at any particular moment.
FullEngineer/SoftEngineer To toggle between Soft- and Full Engineer modes. Full Engineer mode disables
alarms and prevents reporting of events to a central station.
15.6.2 X-Bus Status
1. Select Status > Hardware > X-Bus Status.
The X-Bus Status page displays showing a list of all detected expanders .
2. Select one of the following tabs.
l
Expanders (for programming expanders, see Expanders on page160).
l
Keypads (for programming keypads, see Keypads on page165).
l
Door Controllers (for programming door controllers, see Door Controllers on page168).
3. Click any of the keypad/expander/door controller identifying parameters (ID, description, type,
serial number) to displayed further status details.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 127 I-200572
08.12.2023