Acre SPC42 - Page 168

To Next Page

To Previous Page

15.10.2.3 Door Controllers

Editing a door controller

1. Select Configuration > Hardware > X-Bus > Door Controllers.

2. Click one of the standard keypad identifying parameters (for example, serial number).

3. Configure the fields as described in the table below.

For naming and identifying:

In loop configuration, each expander is numbered consecutively from the first (expander

connected to the 1A 1B on the controller) to the last (expander connected to the 2A 2B on the

controller).

Expander ID ID of the door controller set with the rotary switches.

Type Type of the door controller.

S/N Serial number of the door controller.

Description Description of the door controller.

Door I/O 1

If a door is assigned to the door I/O, select the corresponding door number. If the two

inputs and outputs are configurable, select Zones/Outputs.

If a door number is selected for the door I/O, the door settings can be changed by clicking

on the edit button. This is equal to Settings > Doors.

If Zones/Options is selected, the two zones and the one output can be configured by

clicking the edit button.

Door I/O 2

Profile 1 For readers with a green and a red LED.

Profile 2 For VANDERBILT readers with a yellow LED (AR618X).

Profile 3 Profile 3 is used with HID readers that send a PIN to the panel as a card reading with a

predefined site code (0 )

Profile 4 Profile 4 is used with HID readers that send a PIN to the panel as a card reading with a

predefined site code (255 ).

Profile 5 Select to enable Sesam readers. It is also recommended that you select the Override Reader

Profile option to provide feedback on the setting process.

Editing Zones/Outputs for a Door I/O

1. Select a Zone/Output for the door I/O.

2. Click the Edit button.

3. The 2 inputs and the output belonging to this door I/O can be configured as normal door inputs

and outputs. See Editing a door on page192.

4. In order to use the inputs, they have to be assigned to a zone number.

15.10.2.4 Cable Map

For a list of the expanders/keypads in the order they are configured on the SPC system:

Select Configuration > Hardware > X-BUS > Cable Map & Configuration.

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser

08.12.2023