Acre SPC42 - Configuring Advanced Settings

To Next Page

To Previous Page

15.10.7 Configuring advanced settings

This section covers:

Cause and Effect below

Mapping Gates below

Triggers on the next page

Audio/Video Verification on page205

Updating SPC Licenses on page207

15.10.7.1 Cause and Effect

1. Select Configuration > Advanced > Cause and Effect.

2. Click an Assign button to perform one of the following actions:

Output: Assign a mapping gate (virtual output) to trigger a physical output. Select this

option to display the Mapping Gate - List page. For more information see Mapping Gates

below.

Area: Assign a trigger(virtual input) to trigger an area action. Choose an Area from the

drop-down list before you click the Assign button. For more information see Triggers on

the next page.

Door: Assign a trigger (virtual input) to trigger door action. Choose a Door from the drop-

down list before you click the Assign button.

To display the list of configured triggers and actions, select Configuration > Advanced > Cause &

Effect > Cause & Effect List.

The Cause & Effect List page displays only fully functioning cause & effects. For example, if a

mapping gate is not assigned to a trigger or to a quick key, it is not displayed in the list.

WARNING: Your system will not comply with EN standards if you enable a trigger to set the

system without a valid PIN being required.

15.10.7.2 Mapping Gates

Triggers are used with Mapping Gates, which are virtual outputs defined by the user that can be

mapped to a physical output. There can be a maximum of 512 Mapping Gates.

For continuous output, when the trigger is a valid user code, both states must be the same,

either both negative or both positive.

1. Select Configuration > Advanced > Cause & Effect > Mapping Gates.

2. Enter a Description for the gate. This is important as no mapping gate number, only the

description, is displayed on the Outputs user page for turning on and off gates.

3. Enable the Local setting if you do not want to allow users to turn on and off this gate, even if

they have the right to do so. A local gate is not visible remotely.

4. Enable the Reportsetting to report the status of the mapping gate over FlexC.

5. Select desired Quick Key.

A quick key is a ‘#’ followed by a single digit pressed at the keypad. If a shortcut is configured

and is pressed at the keypad, the user is prompted to turn the output on or off.

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser

08.12.2023