Acre SPC42 - Page 205

To Next Page

To Previous Page

Timer

The value of the timer of the virtual zone (100 ms intervals). The zone

toggles open/closed for the time entered.

4. Click Save to save the information entered and return to the Virtual Zones List page.

Click Add to save the information entered and to re-populate the Create/Edit Virtual Zone page

with details of a new virtual zone, with default values ready to be edited.

The Description, Type and Area values can be edited on the Create/Edit Virtual Zone page and

on the Inputs page (Configuration > Inputs, or via the keypad . The Zone, Mapping gate and

Timer values can only be changed on this page.

See also

Mapping Gates on page200

Triggers on page201

15.10.7.5 Audio/Video Verification

To set up Audio/Video Verification on an SPC system:

1. Install and configure Audio Expander(s).

2. Install and configure Video Camera(s).

3. Install and configure Audio Equipment.

4. Configure Verification Zone(s).

5. Test audio playback from verification zones.

6. Assign Verification Zone(s) to physical zone(s).

7. Configure Verification Settings.

8. View images from verification zones in web browser.

NOTICE: Keypads and access control may be disabled for several minutes while sending an audio

file to the panel, depending on the size of the file.

Configuring Video

Overview

Cameras are used for video verification. The SPC panel supports a maximum of four cameras. Only IP

cameras are supported and the panel must have an Ethernet port.

NOTICE: Cameras must not be shared with other CCTV applications.

Cameras can only be configured with the web browser. Configuration with the keypad is not supported.

The panel supports two camera resolutions:

320X240

This setting is recommended if you want to view images on the browser)

640X480 (with some restrictions).

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser

08.12.2023