The following cameras are supported in addition to other generic cameras:
l
Vanderbilt CCIC1410 (1/4” VGA IP Colour Camera)
l
Vanderbilt CFMC1315 (1/3” 1.3 MP Indoor Dome Colour Camera)
A command string is available as a default to access configuration details for the above cameras
directly. Other generic IP cameras require a command string to be entered manually.
Adding Camera
1. Select Configuration > Advanced > Verification > Video.
A list of any previously configured cameras is displayed and their online or offline status. A
camera is online if an image was obtained from the camera in the previous 10 seconds.
2. Click the Add button to add a new camera or the Edit button to edit an existing camera.
3. Configure the camera with the following parameters:
Camera ID System generated Camera ID.
Description Enter a description to identify this camera.
Type Select from one of the following camera types:
l
Generic
l
Vanderbilt CCIC1410
l
Vanderbilt CFMC1315
Camera IP Enter the IP address of the camera.
Camera Port Enter the TCP port the camera listens on. Default is 80.
Note: The CCIC1410 camera can only be used over port 80 only.
Username Enter a login username for the camera which will be added to the
command string below when the Update Cmd. String button is clicked.
Password Enter a login password for the camera which will be added to the
command string below when the Update Cmd. String button is clicked.
Command
String
Enter the command string to be sent to the HTTP server on the camera in
order to obtain images. This string should include the user name and
password for the camera. Consult the camera documentation for the
specific string required for the camera type selected.
The default command string for a Vanderbilt CCIC1410 or CFMC1315
camera with no password is "/cgi-bin/stilljpeg".
Pre-event
images
Enter the number of pre-event images to record (0–16). Default is 8.
Pre-event
interval
Enter the time interval, in seconds, between pre-event images (1–10).
Default is 1 second.
Post-event
images
Enter the number of post-event images to record (0–16). Default is 8.
Post-event
interval
Enter the time interval, in seconds, between post-event images, in
seconds (1–10). Default is 1 second.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 206 I-200572
08.12.2023
To Next Page