The SPC two way wireless module is fitted into modem slot 2 of the
control panel. See the table below for information on which devices can be enrolled with each type of
SPCW120 Wireless Transceiver.
For CE regulatory compliance, the SPCW120 product can only be fitted to the following products:
l
SPC53
l
SPC63
l
SPC42
l
SPC52
l
SPC5350.320-L1
l
SPC6350.320-L1
Devices compatible with a two way transceiver
Sensors WPIR Wireless 12m PIR detector with pet immunity option
WPIR-CRT Wireless curtain PIR detector
WMAG Wireless magnetic contact (slim)
WMAG-I Magnetic contact with additional input
WSMK Wireless smoke detector
WMAG-S Wireless shock sensor
WPIR-EXT Wireless external PIR sensor
WFLOOD Wireless flood sensor
WGB Wireless Glass Break sensor
Outputs WSIR-INT Wireless indoor sounder
WSIR-EXT Wireless outdoor sounder
Repeaters WRPTR Wireless signal repeater plug
Keypads WKPD Wireless keypad
Fobs WRMT Remote control with 4 button control
WPAN Wireless personal alarm button
For instructional videos on wireless devices and transceivers please go to
http://van.fyi?Link=Wireless_devices
14.9.1 Select a wireless programming option
To select a wireless programming option:
1. Scroll to WIRELESS and press OK.
2. Scroll to the desired programming option. Options are described in the following table:
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 93 I-200572
08.12.2023
To Next Page