Acre SPC42 - Page 94

SENSORS It may be necessary to change the type of sensor enrolled on the system
if the sensor type was incorrectly identified in the enrolment process.
The following options are available for sensors:
l
ADD
See 16.7.1 Add Sensors on page1.
l
EDIT (Change zone assignment)
See Edit Sensors (Zone Assignment) on page1
l
REMOVE
Select the device or sensor to be deleted.
OUTPUTS
l
ADD
See on page1.
l
EDIT
See on page1
l
REMOVE
Select the device or sensor to be deleted.
REPEATERS
l
ADD
See on page1.
l
EDIT
See on page1
l
REMOVE
Select the device or sensor to be deleted.
WPA
1
Add, edit or remove a WPA (Wireless Personal Alarm).
l
ADD
See 16.7.3 Add WPA on page1.
l
EDIT
See 16.7.4 Edit WPA on page1.
l
REMOVE
Select the WPA to be deleted.
SETTINGS
2 WAY
WIRELESS
Enable or disable two way wireless depending on the transceiver you
are using.
Enable two way wireless if you are using SPCW120 Wireless
Transceiver. Disable two way wireless if you are using aSiWay RF Kit
(SPCW120 or WRTX) and not using a SPCW120 Wireless Transceiver.
FILTER LOW
SIGNL
Enableto configure the panel to disregard low strength signals (RF
strengths 0 and 1).
DETECT RF
JAM
Enable to activate an alert on detection of RF interference.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 94 I-200572
08.12.2023