Acre SPC42 - Edit

2. Press ENTER to accept the default user name or enter a customized user name and press
ENTER.
3. Scroll to the preferred user profile type and press ENTER to select.
The system generates a default PIN for each new user.
4. Press ENTER to accept the default user PIN or enter a new user PIN and press ENTER.
The keypad confirms that the new user has been created.
14.7.2 Edit
To edit users on the system:
1. Scroll to USERS>EDIT.
2. Press OK.
3. Edit the desired user setting shown in the table below.
CHANGE
NAME
Edit the current user name
USER
PROFILE
Select the appropriate profile for this user.
DATE LIMIT Enable this if the user can only access the system for a specified period of
time. Enter a FROM and TO date and press ENTER.
PACE Enable or disable PACE capability
RF FOB Enable or disable RF Fob access (wireless keypad, remote control)
MAN-DOWN
(MDT)
Enables the man-down test.
ACCESS
CONTROL
If no card assigned to the user:
l
ADD CARD
l
LEARN CARD
If a card assigned to the user:
l
EDIT CARD
– CARD NUMBER
– CARD ATTRIBUTES
l
RESET CARD
l
DELETE CARD
LANGUAGE Select a language for this user that will be displayed on the system.
14.7.2.1 Access Control
One access card can be assigned to each of the users on the control panel.
To configure the access control for a user:
1. Scroll to USERS>EDIT.
2. Press OK.
3. Select the user which should be configured and press OK.
4. Scroll to ACCESS CONTROL and press OK.
The following sections provide programming steps found within the access control option of the selected
user.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 89 I-200572
08.12.2023