open door itself.
This output could be connected, for example, to a red LED or light to indicate that the door could
not be opened, and if inverted could be connected to a green LED or light.
To configure an output for door interlock.
1. In Full Engineer mode, select Configuration > Hardware > X-BUS > Expanders.
2. In the Expander Configuration page, click the Change Type button for the required output.
3. Select Door as the output type.
4. Select the required door and Interlocked as the output type.
15.10.4.4 Adding an area group
You can use area groups for configuring multiple areas. So the configuration must not be done for every
single area.
Prerequisite
o
Only if the option (multiple) Areas is activated.
1. Select Settings > Areas > Area groups.
2. Click the Add button.
3. Enter a description for the group.
4. Select the areas that are to be assigned to this group.
5. Click Add.
NOTICE: To use the area groups for the Comfort Keypad, activate all Areas in the Areas field under
Configuration > Hardware > X-BUS > Keypads > Type: Comfort Keypad.
15.10.5 Calendars
Calendars are used for scheduling time-based control for multiple panel operations as follows:
l
Automatic setting and/or unsetting of areas
l
Automatic setting and/or unsetting of other panel operations including triggers, enabling of users,
zones, physical outputs, etc.
At any particular time, any schedule within the calendar can be ‘active’ if its time conditions are satisfied.
Each week of the year is assigned an ordinal number. Depending on the fall of days within a month,
there may be 52 or 53 weeks in one year. The SPC calendar implementation conforms to the
ISO8601international standard.
Configuring calendars
l
Select Configuration > Calendars.
A list of configured calendars is displayed.
Performable actions
Add Add a new calendar.
Exceptions Configure setting schedules for exceptional circumstances outside of the normal weekly
schedules
Edit/View Edit or view the selected calendar.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 197 I-200572
08.12.2023
To Next Page