The card is unassigned from the user and deleted from the system.
3. To add the card again, you must rescan it.
15.8.2 Adding/Editing User Profiles
NOTICE: Global user profiles cannot be edited in the browser and must be edited in SPC Manager.
To add or edit a user profile:
1. Select Users>User Profiles.
A list of configured profiles displays with the number of users assigned to each profile.
2. Click Add User Profile or click the Edit button of the required profile.
The configuration options are categorized as follows:
- General Settings
- User/Panel Rights
- Access Control
General Settings
1. Enter a User Profile ID that is not currently being used. If you enter an ID that is already used, an
‘ID Unavailable’ message is displayed.
2. Provide a User Profile Name (maximum 16 characters and case sensitive).
3. Select all Areas that will be controlled by this user profile.
4. Select a Calendar to set the time limitations of this profile on the system.
User/Panel Rights
l
Select the required user rights that are to be assigned to this user profile.
User rights
Right
User Profile
Type
Default
Description
User Rights - Intruder
Unset Limited
Standard
Manager
The UNSET operation unsets the alarm. This menu option is only presented on
the keypad after an Entry/Exit zone has been activated and a valid user code has
been entered.
Partset A Standard
Manager
The PARTSET A option provides perimeter protection to a building while allowing
free movement through the access areas.
Zones that have been classified as EXCLUDE A remain unprotected in this mode.
By default, there is no exit time; the system sets instantly on selection of this
mode. An exit timer can be applied to this mode by enabling the Partset A timed
variable.
Partset B Standard
Manager
The PARTSET B option applies protection to all zones except those that have
been classified as EXCLUDE B.
By default there is no exit time; the system sets instantly on selection of this mode.
An exit timer can be applied to this mode by enabling the Partset B timed variable.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 141 I-200572
08.12.2023
To Next Page