3. Press the right soft key on the keypad after each display to view expanders, zones and offline
items.
4. Press this key again to exit.
Refresh makes no changes to the system, but is useful for detecting system faults, such as
loose connections, or inactive expanders, before performing a Reconfigure.
14.6.3 Reconfigure
NOTICE: A reconfigure only applies to wired zones on an expander. Wireless zones on an
expander and controller zones will not be brought online after a reconfigure. To bring controller
zones online, you must apply a zone type other than ‘Unused’ using the zones menu on the
keypad or web browser.
If the system has a mixture of expander types (with and without rotary switches) then the system can
only be automatically reconfigured. If the system has all expanders with rotary switches, the system
can still be automatically reconfigured and the system will ignore the rotary switches and auto
addresses all the expanders on the system.
It is recommended that you perform a Refresh before a Reconfigure.
To reconfigure keypads/expanders:
1. Scroll to RECONFIGURE.
2. Press SELECT.
The number of online keypads is displayed.
3. Press NEXT.
The number of online expanders is displayed.
4. Press NEXT
The number of online zones is displayed.
5. Press BACK to exit.
14.6.4 Keypads/Expanders/Door Controllers
14.6.4.1 Locate
To locate a keypad/expander/door controller:
1. Scroll to KEYPADS, EXPANDER or DOOR CONTROLLER and press SELECT.
2. Scroll to LOCATE and press SELECT.
3. Scroll to the expander/keypad/door controller to be located and press SELECT.
The selected device beeps and the LED flashes to enable the Engineer to locate the device.
4. Press BACK to exit.
Locate keypads using the same menus and following the keypad choice instead of expander.
14.6.4.2 Monitor
To obtain an overview of the keypads/expanders/door controller connected to the system:
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 78 I-200572
08.12.2023
To Next Page