Acre SPC42 - Page 79

1. Scroll to KEYPADS, EXPANDER or DOOR CONTROLLER and press SELECT.
2. Scroll to MONITOR and press SELECT.
3. Scroll to desired Monitor programming option.
4. Press SELECT.
A list of detected keypads/expanders is displayed.
5. Scroll through the list and press SELECT on preferred expander/keypad/door controller.
Parameters and details, if applicable, are displayed for editing as shown in the table below.
STATUS Online or offline
S/N Serial number (used to track and identify)
VER Firmware version
POWER Power parameters: real-time voltage and current readings
ADDRESS
INFO
The addressing mode and the address of the keypad/expander/door
controller.
AUX FUSE The status of the auxiliary fuse on the expander/door controller
PSU The type and status of the PSU. (PSU expanders only) Scroll to display the
voltage and current load on the outputs, the battery status. The Mode Link
option is also available, which shows the jumper setting on the panel for the
Ah setting. 7Ah and 17Ah are the available options. (This jumper is not
present on the 5350 or 6350 models)
If you are using the SPC 5360 or 6350, this menu displays the battery status,
and the status of the fuses on the outputs.
BATTERY Battery voltage: battery voltage level (PSU expanders only)
INPUT
STATE
State of each zone input associated with an expander as follows:
C: Closed, O: Open, D; Disconnected, S: Short (Expanders with inputs only)
6. Press BACK to exit.
14.6.4.3 Edit Keypads
To edit keypads:
1. Scroll to KEYPADS > EDIT.
2. Press SELECT.
3. Scroll to the device to be edited and press SELECT.
The configuration settings for a standard keypad and comfort keypad are described in the
sections below.
4. Press BACK to exit the menu.
LCD Keypad Settings
Configure the following settings for the keypad.
Setting Description
Description Enter a unique description to identify the keypad.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad
© Vanderbilt 2023 79 I-200572
08.12.2023