Acre SPC42 - Flexc Commands

Acronym EN50136-1 Description FlexC Example
ATS Alarm Transmission System
ATE and networks used to transfer information concerned
with the state of one or more ASs at a supervised premises to
one or more AEs of one or more ARCs. An ATS may consist
of more than one ATP.
A system combining one or
multiple paths between SPC
panel and SPC Com XT.
RCT Receiving Centre Transceiver
ATE at the ARC including the interface to one or more AE(s)
and the interface to one or more transmission networks and
being part of one or more ATPs. In some systems this
transceiver may be able to indicate changes of the status of
an AS and to store log-files. This may be needed to increase
the ATS availability in case of AE failure.
SPC Com XT Server
SPT Supervised Premises Transceiver
ATE at the supervised premises including the interface to the
AS and the interface to one or more transmission networks
and being part of one or more ATPs.
Integrated onto SPC Panel using
Ethernet, GPRS, PPP over
PSTN.
FlexC also uses the following acronyms.
Acronym Description
ASP Analogue Security Protocols
The analogue security protocols traditionally used for alarm transmission over the telephone
network, for example, SIA, Contact ID.
21.19 FlexC Commands
The following table lists the commands that you can enable for a command profile. The command profile
you assign to an ATS defines how you can control a panel from SPC Com XT.
Command Filter Commands
System Commands Get Panel Summary
Set the System Time and Date
Grant Engineer Access
Grant Manufacturing Access
SPC42/52/53/63 – Installation & Configuration Manual Appendix
© Vanderbilt 2023 289 I-200572
08.12.2023