Acre SPC42 - Page 290

Command Filter Commands
Intruder Commands Get the Area Status
Get the Change Mode Status of an Area
Change the mode (Set/Unset) of an Area
Get Status of Panel Alerts
Perform actions on Alerts
Silence Bells
Get Zone Status
Control a Zone
Get the System Log
Get the Log for a Zone
Get the Wireless Log
Get Holdup Data
Edit Holdup Data
Output Commands Get Mapping Gate Status
Control Mapping Gates
User Commands Verify a User on the Panel
Get a User Configuration
Add a User
Edit a User
Delete a User
Get a User Profile Configuration
Add a User Profile
Edit a User Profile
Delete a User Profile
Change a User's own PIN
Get User Status
Clear All Alerts
Get Unknown Cards
SPC42/52/53/63 – Installation & Configuration Manual Appendix
© Vanderbilt 2023 290 I-200572
08.12.2023