Acre SPC42 - SMS Commands

SMS
Number
Enter the number to which the SMS will be sent (requires three-digit country
code prefix).
Note: Engineer SMS number can deleted by resetting it 0. User SMS
numbers cannot be deleted.
SMS
Events
Select the panel events which the user or engineer will receive via SMS.
SMS
Control
Select the operations that the user or engineer can perform remotely on the
panel through SMS. See SMS Commands below.
NOTICE: HOLDUP alarm events are not transmitted via SMS.
If the phone line is connected to the PSTN network via a PBX, the appropriate line access digit
should be inserted before the called party number. Ensure that Calling Line Identity (CLI) is enabled
on the line selected to make the call to the SMS network. Consult the PBX administrator for details.
15.8.4 SMS Commands
When the SMS setup and configuration is complete, SMS features may be activated. Commands,
depending on SMS configuration, are sent using a PIN or caller ID. The type of PIN depends on what is
set for SMS Authentication.
The table below provides all available SMS commands. Subsequent action and response are also
provided.
SMS Commands are sent as texts to the phone number of the SIM card on the controller.
For commands using a PIN, the format of the text is:
****.command or **** command
where **** is the PIN and “command” is the command, that is, the PIN followed by either a space or a full
stop. For example, the command “FSET” is entered as: **** FSET or ****.FSET. The full version of the
command, where listed, can also be used. For example, ****.FULLSET.
If the user does not have sufficient rights to perform a command, the system returns ACCESS DENIED.
If Caller ID is enabled, and the sender’s SMS number is configured, the PIN prefix is not required.
COMMANDS (****=code)
Using Code
Using Caller
ID
Action Response
****HELP
****.HELP
HELP All available commands are
displayed.
All available commands
****FSET
****.FSET
****.FULLSET
FSET
FULLSET
Sets all areas the user has access
to.
Time/date of system set. If
applicable, responds with
open zones/force set zones
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 145 I-200572
08.12.2023