Acre SPC42 - Data Entry on the LCD Keypad

– XBUS power supply fault
– XBUS fuse fault
– XBUS tamper fault
– XBUS antenna fault
– XBUS wireless jamming
– XBUS panic
– XBUS fire
– XBUS medical
– XBUS Power supply link
– XBUS output tamper
– XBUS Low voltage
– Engineer restore Required
– Autoarm
l
System information
– Soaked zones
– Open zones
– Area state
– Low battery (sensor)
– Sensor lost
– WPA* low battery
– WPA* lost
– WPA* test overdue
– Camera offline
– Fob low battery
– Xbus over current
– Installer name
– Installer phone
– Engineer enable
– Manufacture enable
– Reboot
– Hardware fault
– Aux over current
– Battery low
– Ethernet link
– System name
* A WPA is compatible with Wireless Module SPCW120,WRTX.
11.1.3 Data entry on the LCD keypad
Entering data and navigating the menus on the LCD keypad is facilitated through the use of the
programming interface. The use of the interface for each type of operation is detailed below.
SPC42/52/53/63 – Installation & Configuration Manual Keypad user interface
© Vanderbilt 2023 57 I-200572
08.12.2023