Entering numeric values
In Numeric Entry mode, only the numeric digits (0–9) can be entered.
l
To move the position of the cursor one character to the left and right respectively, press the left
and right arrow keys.
l
To exit from the feature without saving, press the BACK menu key.
l
To save the programmed setting press ENTER or OK.
Entering text
In Text Entry mode, both alphabetic characters (A–Z) and numeric digits (0–9) can be entered.
l
To enter an alphabetic character, press the relevant key the required number of times.
l
To enter a language specific special character (ä, ü, ö…) press button 1 to cycle through the
special characters.
l
To enter a space + special characters (+, -./[]…) press button 0.
l
To enter a digit, hold the relevant key down for 2 seconds and release.
l
To move the position of the cursor one character to the left and right respectively, press the left
and right arrow keys.
l
To exit from the feature without saving, press BACK.
l
To save the programmed setting press ENTER or OK.
l
To change the case of an alphabetic character, press the up/down arrow keys when the
character is highlighted by the cursor.
l
To toggle between upper and lower case for all subsequent characters, press the hash (#) key.
l
To delete character to the left of the cursor, press the star key(*).
Selecting a programming option
In navigation mode, the Engineer/User selects one of a number of pre-defined programming options
from a list.
l
To scroll through the list of options available for selection, press the up and down arrow keys.
l
To exit from the feature without saving, press BACK.
l
To save the selected option, press SAVE or OK.
SPC42/52/53/63 – Installation & Configuration Manual Keypad user interface
© Vanderbilt 2023 58 I-200572
08.12.2023
To Next Page