Acre SPC42 - Page 90

To Next Page

To Previous Page

Add Card manually

If the card format of the card number is known, the card can be created manually.

The site code of the card is configured for the user profile that is assigned for this user.

1. Scroll to ADD CARD.

2. Press OK.

An empty card has been added and can now be edited.

Learn Card

NOTICE: Only cards with supported card formats can be learned.

If the card number or the card format is not known, the card can be read and its information learned.

1. Scroll to LEARN CARD.

2. Press OK.

3. Select the door that the card will be presented.

4. Press OK.

NOTICE: The new card can be presented at the entry or the exit reader of the

selected door.

5. Present the card at a card reader at the selected door.

The information for the new card is learned.

Edit Card

If an access card is already assigned to a user it can be changed via the keypad:

1. Scroll to EDIT CARD.

2. Press OK.

3. Edit the desired user setting shown in the table in Access Control below.

4. Press BACK to exit.

Access Control

Attribute Description

Card

Number

Enter card number. Enter 0 to unassign this card.

Void Card Check to temporarily disable this card.

Extended

Time

Extend door timers when this card is present.

PIN bypass Access a door without PIN on a door with PIN reader.

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad

08.12.2023