Acre SPC42 - Page 167

Audible indications
Alarms Select speaker volume for alarm indications or disable sound.
Entry/Exit Range is 0–7 (Max volume)
Chime Select speaker volume for entry and exit indications or disable sound.
Keypress Range is 0–7 (Max volume)
Voice
Annunciation
Select speaker volume for chime or disable sound.
Partset Buzzer Range is 0–7 (Max volume)
Quiet Mode Enable this setting to disable the buzzer during entry and exit when the
keypad is in an armed area.
NOTE: Keypad only audible for entry/exit/setting/unsetting if the area is
the same as the keypad location, or if the keypad is performing the
operation.
Deactivation
Calendar Select if the keypad should be limited by calendar. See Calendars on
page197.
Mapping gate Select if keypad should be limited by a mapping gate.
Keyswitch Select if keypad should be limited by a keyswitch.
PACE Entry Tick this box to disable the keys on the keypad during the entry time
when a PACE is configured on the keypad.
Areas
Location Select the secured area where the keypad is located.
Areas Select which areas can be controlled through keypad.
Options
Delay Fullset Select to configure a delayed set across all keypads. The location of the
keypad is ignored and all areas will perform a full exit time count down.
Keypad Access
Level
Select keypad access level (1 to 3).
Level 1 – All functions
Level 2 – Arm, disarm, and restore only
Level 3 – View only
NOTICE: An area should be assigned to a keypad only if the keypad is inside the assigned area,
and if an entry/exit route is defined. If an area is assigned, when the particular area is set or unset
then entry and exit timers are used (if configured). Other features related to entry/exit routes also
become available. If no area is assigned, the area is set or unset immediately and other entry/exit
features are not available.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 167 I-200572
08.12.2023