Acre SPC42 - Page 166

To Next Page

To Previous Page

NOTICE: An area should be assigned to a keypad only if the keypad is inside the assigned area,

and if an entry/exit route is defined. If an area is assigned, when the particular area is set or

unset then entry and exit timers are used (if configured). Other features related to entry/exit

routes also become available. If no area is assigned, the area is set or unset immediately and

other entry/exit features are not available.

See also

Calendars on page197

Editing a Comfort Keypad

1. Select Configuration > Hardware > X-Bus > Keypads.

2. Click one of the comfort keypad identifying parameters.

3. Configure the fields as described in the table below.

Description Enter a unique description to identify the keypad.

Function Keys (in idle state)

Panic Select Enable, Disable or Enabled Silent. If enabled, panic alarm is

activated by pressing F1 and F2 soft keys together.

Fire Enable to allow fire alarm to be activated by pressing F2 and F3 soft

keys together.

Medical Enable to allow medical alarm to be activated by pressing F3 and F4

soft keys together.

Fullset Enable to allow Fullset to be activated by pressing F2 key twice.

Partset A Enable to allow Partset A to be activated by pressing F3 key twice.

Partset B Enable to allow Partset B to be activated by pressing F4 key twice.

Visual indications

Backlight Select when keypad backlight is on. Options are: On after key is

pressed; Always on; Always off.

Backlight

Intensity

Select the intensity of illumination of the backlight. Range 1–8 (High).

Indicators Enable or disable the LED’s on the keypad.

Setting state Enable if setting state should be indicated in idle mode. (LED)

Logo Enable if logo should be visible in idle mode.

Analog Clock Select position of clock if visible in idle mode. Options are Left Aligned,

Center Aligned, Right Aligned or Disabled.

Emergency

Keys

Enable if Panic, Fire and Medical function keys should be indicated in

the LCD display.

Direct Set Enable if Fullset/Partset function keys should be indicated in the LCD

display.

Human Icon Enable if Mapping Gate should be indicated.

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser

08.12.2023