Acre SPC42 - Page 209

ENMP
change
enabled
Selerct this option to enable network changes to be made with ENMP
protocol.
15.11.1.2 Ethernet
The Ethernet port on the controller can be configured from both the browser and keypad interfaces. An
Ethernet connection with the SPC controller can be established using a direct connection or a LAN
connection.
1. Select Communications > Communications > Ethernet.
2. Configure the fields as described in the table below.
IP address Enter the IP address of the panel.
IP Network Enter the subnet mask that defines the type of network address structure
implemented on the Local Area Network (LAN).
Gateway
IP Address
Enter the IP address of the IP gateway if one exists. This is the address that IP
packets will be routed through when accessing external IP addresses on the
internet.
DNS
Server
Enter the IP address of the DNS server
Enable
DHCP
Click this Button to enable dynamic address assignment on the panel.
15.11.1.3 Configuring Modems
The SPC panel provides two on-board modem interface connectors (primary and backup) that allow you
to install GSM and/or PSTN modules onto the system.
The SMS test is provided only for the purpose of ensuring the SMS feature is operating correctly. A
short text message using alphabetic characters (A-Z) should be used to test this feature.
After a factory default, during the process of initial setup of the system with the keypad, the panel
detects if it has a primary or backup modem fitted, and if so, it displays the modem type and
automatically enables it (or them) with the default configuration. No other modem configuration is
allowed at this stage.
To program the modem(s):
Note: A modem must be installed and identified. (See section Installing plug-in modules on page49.)
1. Select Communications > Communications > Modems.
2. Click Enable.
3. Click Configure.
l
If you have installed a GSM Modem, the GSM Modem settings page displays.
For more information, see GSM modem on page211.
l
If you have installed a PSTN modem, the PSTN Modem settings page displays.
For more information, see PSTN modem on page213.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 209 I-200572
08.12.2023