Acre SPC42 - Page 211

l
SMS PIN Only: This is a valid PIN code configured for the user which different from the user’s
login code. Only when this option is selected will the SMS Controls be available for
configuration by the user.
l
SMS PIN & Caller ID
SMS commands
See SMS Commands on page145 for more information.
GSM modem
Prerequisite
o
A GSM modem must be properly installed and functioning correctly.
1. Select Communications > Communications > Modems.
2. Click Configure.
3. Configure the following fields.
GSMModem settings
Country Select the country that the SPC system is installed in.
SIM PIN Enter the PIN for the SIM card installed in the GSM module.
Wireless
Technology
GSM only
Select the signal type that you wish to the modem to use:
l
The SPC 320 is a 2G/4G Modem
l
The SPC342 is a 2G/3G/4G modem
Allow
Roaming
Select to enable GSM roaming.
Warning: If this option is enabled, the modem can connect to a network in a different country.
Note: Changing this setting resets the modem.
Note: Supported on GSM modems v3.08 or higher.
USSD Pay-As-You-Go SIM only
Enter the code that the modem can use to query the network for the credit balance of the SIM.
This code is network-dependent, please check with your service provider.
Incoming
Calls
Note: Vanderbilt recommend that these options are not enabled for current systems.
The modem can be programmed to answer calls based on the following conditions:
l
Don’t answer incoming calls: The modem never answers calls.
l
Answer incoming calls: The modem answers incoming calls.
l
Only answer when ‘Engineer Access’ is granted: The modem only answers the call
while engineer access is granted to the system.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 211 I-200572
08.12.2023