4. Activate the wireless sensor by inserting the battery/batteries to enable the SPCW120 Wireless
Transceiver to detect the wireless transmission of the device.
When the sensor is detected, it is listed on the Wireless - Discovering page. The sensor
information may display automatically after a few seconds or you may have to click the Refresh
button to see the wireless sensor information.
5. Click Add.
6. Use the settings in the Wireless Device Configuration page to specify a Description and to
configure the other settings for the wireless sensor.
See Configuring two way wireless attributes on page1 for more information.
7. Click Save.
The wireless sensor is enrolled in your SPC system, and the device is added to the Wireless -
Enrolled List page.
15.9.1.2 Configure wireless smoke detector LED
For more recent smoke detectors (v 0.2.0.3 and higher), you can configure the following settings
l
Enable / disable LED
l
Set the supervision time set to 1/2/4/7/10/15/20/30 minutes
In order to configure these settings, the smoke detectors must be communicating through a wireless
transceiver with firmware version 4.7 or later, on anSPC system version 3.13.5 or later.
Go to Hardware > Wireless > Two Way > Wireless Device Configuration to configure the LED
settings.
15.9.1.3 Add wireless output
Add a wireless output using the browser
To add a wireless output using the browser:
1. Select Configuration > Hardware > Wireless Settings.
2. Enable Two Way Wireless.
3. Select Configuration > Hardware > Wireless > Two Way and click Enrol New Device.
4. Activate the wireless output by inserting the battery/batteries to enable the SPCW120 Wireless
Transceiver to detect the wireless transmission of the device.
When the output is detected, it is listed on the Wireless - Discovering page. The output
information may display automatically after a few seconds or you may have to click the Refresh
button to see the wireless output information.
5. Click Add.
6. Use the settings in the Wireless Device Configuration page to specify a Description and to
configure the other settings for the wireless output.
See Configuring two way wireless attributes on page1 for more information.
7. Click Save.
The wireless output is enrolled in your system, and the device is added to the Wireless - Enrolled
List page in the Outputs List section.
15.9.1.4 Add wireless repeater
Add a wireless repeater using the browser
To add a wireless repeater:
1. Select Configuration > Hardware > Wireless Settings.
2. Enable Two Way Wireless.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 151 I-200572
08.12.2023
To Next Page