Acre SPC42 - Page 152

To Next Page

To Previous Page

3. Select Configuration > Hardware > Wireless > Two Way and click Enrol New Device.

4. Activate the wireless repeater by inserting the battery/batteries and then plug the WRPTR into

an EU mains (220v AC) socket.

Activating the repeater enables the SPCW120 Wireless Transceiver to detect the wireless

transmission of the device. When the repeater is detected, it is listed on the Wireless -

Discovering page. The repeater information may display automatically after a few seconds or

you may have to click the Refresh button to see the wireless repeater information.

5. Click Add.

6. Use the settings in the Wireless Device Configuration page to specify a Description and to

configure the other settings for the wireless repeater.

See Configuring two way wireless attributes on page1 for more information.

7. Click Save.

The wireless repeater is enrolled in your system, and added to the Wireless - Enrolled List

page in the Repeaters List section.

15.9.1.5 Add wireless keypad

Add a wireless keypad using the browser

To add a wireless keypad using the browser:

1. Select Configuration > Hardware > Wireless Settings.

2. Enable Two Way Wireless.

3. Select Configuration > Hardware > Wireless > Two Way and click Enrol New Device.

4. Activate the wireless sensor by inserting the battery/batteries to enable the SPCW120

Wireless Transceiver to detect the wireless transmission of the device.

When the keypad is detected, it is listed on the Wireless - Discovering page. The keypad

information may display automatically after a few seconds or you may have to click the

Refresh button to see the wireless keypad information.

5. Click Add.

6. Use the settings in the Wireless Device Configuration page to specify a Description and to

configure the other settings for the wireless keypad.

See Configuring two way wireless attributes on page1 for more information.

7. Click Save.

The wireless keypad is enrolled in your SPC system, and the device is added to the Wireless -

Enrolled List page.

15.9.1.6 Add wireless personal alarm button

Add a wireless personal alarm button using the browser

To add a wireless personal alarm button using the browser:

1. Login as Full Engineer.

2. Select Users > Wireless FOB.

3. On the wireless personal alarm button, press and hold the centre button.

4. The Red LED lights for 3 seconds, then no LED, then Red LED once and then Green LED.

5. Click Refresh on the Wireless FOB page to display the wireless personal alarm button.

6. You can now assign the discovered wireless personal alarm button to a system user.

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser

08.12.2023