Acre SPC42 - Page 131

To Next Page

To Previous Page

Medical Keypad medical alarm status.

Code Tamper Keypad PIN tamper alarm status

Performable actions

Restore

Alerts

Click the button to restore all alerts on the panel.

Inhibit Click this button to inhibit a fault condition. The inhibit operation will disable that fault or zone for one

arming period only.

Inhibit operation is not available in Security Grade EN 50131 Grade 3.

Isolate Click this button to isolate that zone. Isolating a zone will de-activate that zone until such time as the

zone is explicitly de-isolated again. It is recommended that you exercise caution when isolating

zones as those zones will not be active every time the system is SET.

15.6.2.4 Door Controller Status

1. Select Status > Hardware > X-Bus Status.

2. Select the Door Controllers tab.

A list of detected door controllers is displayed.

The following table shows the information that is available.

Name Description

Expander ID This ID number is a unique identifier for the door controller.

Description Text description of the door controller (max. 16 characters).

Type The type of expander detected (=door controller).

S/N The serial number of the door controller.

Version The firmware version of the door controller.

Comms The status of the door controller (online or offline).

Status The status of the door controller (OK, Fault).

PSU Specifies if the door controller has a PSU.

Performable actions

Refresh Click the Refresh button to update the status of the system alerts.

To view more status information:

Click a door controller’s identifying parameters (ID, description, type, serial number) to display

further status details.

The following table shows the information that is available.

Communication The physical status (OK, Fault) and the programmed status (OK, Isolated, Inhibited) of the

keypad cable connection to the expander.

Housing Tamper The physical and programmed status of the expander housing tamper.

Fuse Fault The physical and programmed status of the door controller fuse.

Code Tamper Status of the user’s PIN. Multiple failed attempts result in an alert.

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser

08.12.2023