Acre SPC42 - Page 130

Name Description
Load voltage The voltage on the PSU
Load Current The current drawn by the PSU.
Charge Status Displays the condition of the battery charge.
Primary Circuit Displays the condition of the primary circuit which supplies power when the mains is
connected.
Charge Circuit Displays the condition of the charge circuit which charges the batteries when the mains is
connected.
Battery Displays the charge status, voltage and current available from the batteries.
Outputs Displays the voltage, fuse condition and tamper condition of the PSU outputs.
15.6.2.3 Keypad Status
1. Select Status > Hardware > X-Bus Status.
2. Select the Keypads tab.
A list of detected keypads is displayed.
The following table shows the information that is available.
Name Description
Expander ID This ID number is a unique identifier for the keypad.
Description Text description of the keypad (max. 16 characters).
Type The type of expander detected (=keypad).
S/N The serial number of the keypad.
Version The firmware version of the keypad.
Comms The status of the keypad (online or offline).
Status The status of the keypad (OK, Fault).
Performable actions
Refresh Click the Refresh button to update the list of detected keypads and their status.
To view more status information:
l
Click a keypad’s identifying parameters (ID, description, type, serial number) to display further
status details.
The following table shows the information that is available.
Communication The physical status (OK, Fault) and the programmed status (OK, Isolated, Inhibited) of
the keypad cable connection to the expander.
Housing Tamper The physical and programmed status of the expander housing tamper.
PACE Applies only to Keypads with a PACE receiver installed.
Panic Keypad panic alarm status.
Fire Keypad Fire alarm status.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 130 I-200572
08.12.2023