Acre SPC42 - Page 129

Name Description
Inhibit Click this button to inhibit a fault condition. The inhibit operation will disable that fault or zone for
one arming period only.
Inhibit operation is not available in Security Grade EN 50131 Grade 3.
Isolate Click this button to isolate that zone. Isolating a zone will de-activate that zone until such time as
the zone is explicitly de-isolated again. It is recommended that you exercise caution when
isolating zones as those zones will not be active every time the system is SET.
See also
PSU status below
15.6.2.2 PSU status
The PSU Status page displays details of the current status of the PSU and its outputs in addition to the
status of any connected batteries.
The following PSU types are supported:
l
SPCP332/333 Smart PSU
l
SPCP355.300 Smart PSU
SPCP332/333 Smart PSU Status
The following table shows the information that is available.
Name Description
Type The type of power supply unit (PSU).
Version The version of the PSU.
Mains Status Displays the condition of the mains connection. Possible values are Fault or OK.
Battery Link Displays the type of battery connected.
Battery
Status
Displays the condition of the battery connection. Possible values are Fault or OK.
Battery
Voltage
Displays the voltage reading of the battery.
Battery
Current
Displays the current taken from the battery.
Outputs Displays the voltage on the outputs, the current drawn by the output and the condition of the fuse
on the output.
SPCP355.300 Smart PSU Status
The following table shows the information that is available.
Name Description
Type The type of power supply unit (PSU).
Version The version of the PSU.
Mains Status Displays the condition of the mains connection. Possible values are Fault or OK.
Temperature Displays the temperature of the PSU.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 129 I-200572
08.12.2023