For instructional videos on wireless devices and transceivers please go to
http://van.fyi?Link=Wireless_devices.
15.6.3.1 View a list of wireless sensors
To view a list of wireless sensors and information about the sensors, select Configuration > Hardware
> Wireless.
The following table shows the information that is available.
Wireless sensor information
Wireless
Sensor
The number of the sensor enrolled on the system (1=first, 2=second, etc.).
ID A unique identity number for that sensor.
Type The type of wireless sensor detected (magnetic contact, inertia/shock, etc.).
Zone The zone to which the sensor has been enrolled.
Battery The status of the battery in the sensor.
Supervise The status of the supervisory operation (OK=supervisory signal received, Not Supervised=no
supervisory operation).
Signal The signal strength received from the sensor (01=low, 09=high).Note: Although it is not possible
to enroll a device with a signal strength less than 3, devices whose signal drops below 3 after
enrolment are not dropped.
Version The version details of the sensor.
Status Actuated, Normal,Tamper, Unknown
Performable actions
Log Click to view the wireless sensor Log. See Log - Wireless sensor X below.
Enrol New Sensor Click to enrol a new sensor.
Refresh Click to refresh the list of enrolled sensors.
Edit Click to edit the sensor attributes.
Remove Click to remove the sensor from the enrolled sensors list.
15.6.3.2 Log - Wireless sensor X
To view a quick log of events for a wireless sensor:
1. Click the Log button in the table row for that sensor.
2. The Message log for the sensor displays.
3. Optionally, you can create a text file of the log by clicking Text File.
Information provided in the message log
Time The date and time of the logged event.
Receiver The wireless receiver location, that is, wireless module mounted on the keypad, controller or
wireless expander.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 133 I-200572
08.12.2023
To Next Page