Acre SPC42 - Page 148

Access Control
Attribute Description
Card
Number
Enter card number. Enter 0 to unassign the card.
Void Card Check to temporarily disable the card.
Extended
Time
Extend door timers when the card is present.
PIN bypass Access a door without PIN on a door with PIN reader.
Priority Priority cards are stored locally in the door controllers and will grant access in case of a
technical fault where the door controller cannot communicate with the control panel.
The maximum number of priority users is:
l
SPC42 –500
l
SPC52 – 500
l
SPC53 – 500
l
SPC62 – 500
Escort The escort feature enforces privileged card holders to escort other card holders through
specific doors. If this feature is enabled on a door, a card with the “escort” right has to be
presented first, to allow other cardholders without this right to open the door. The time period in
which cardholders are able to present their cards after a card with escort right was presented,
can be configured per door.
Custodian The custodian feature enforces a card holder with custodian privilege to always be inside a
room (door group) when other card holders are inside.
The custodian must be the first to enter the room. Only if a custodian is in the room other
cardholders are allowed to enter. The cardholder with the custodian right will not be allowed to
exit until all non-custodian cards left the room.
Identifies this card holder as a custodian. The user with the custodian attribute has to be the
first who enters a door group which requires a custodian card holder and has to be the last that
is leaving this door group.
15.8.6.1 Changing Engineer PIN and web password
You can change the PIN for accessing the keypad and also the password for accessing the Web
browser for Engineer level only.
1. Change the PIN as follows:
Old PIN Enter the existing Engineer PIN code. (Numeric digits only)
New PIN Enter the new Engineer PIN code. (Numeric digits only)
Confirm New PIN Re-enter the New Engineer PIN code.
2. Click the Change PIN button to activate the new PIN.
The minimum number of digits required for the code depends on the security
setting of the system or on the selected length of the PIN Digits in the menu
Panel Settings > System Settings > Options.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 148 I-200572
08.12.2023