Configure Advanced ATP Settings
WARNING: It is not recommended to change Advanced ATP Settings. Changes must only be
made by expert users.
1. Click the Advanced ATP Settings button.
Configure the fields described in the table below.
ATP Connections
Active ATP
Connection
Select the ATP connection type when the ATP is operating as the primary
communication path.
l
Permanent: Stay Connected
l
Temporary: Hangup 1second
l
Temporary: Hangup 20 second
l
Temporary: Hangup 80 second
l
Temporary: Hangup 3 minutes
l
Temporary: Hangup 10 minutes
l
Temporary: Hangup 30 minutes
Non-active
ATP
Connection
Select the ATP connection type when the ATP is operating as a backup
communication path.
l
Permanent: Stay Connected
l
Temporary: Hangup 1second
l
Temporary: Hangup 20 seconds
l
Temporary: Hangup 80 seconds
l
Temporary: Hangup 3 minutes
l
Temporary: Hangup 10 minutes
l
Temporary: Hangup 30 minutes
Test Calls
Test Call
Mode (Non
Active ATP)
Select the mode for sending test calls when the ATP is the non-active ATP.
l
Test calls Disabled
l
Test call every 10 minutes
l
Test call every 1 hour
l
Test call every 4 hours
l
Test call every 24 hours
l
Test call every 48 hours
l
Test call every 7 days
l
Test call every 30 days
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 221 I-200572
08.12.2023
To Next Page