1. To configure an Event Exception Definition, complete the fields described in the table below.
Identification
Name Enter the name of the Event Exception.
Event ID Event ID of the event on the system. This is display only.
Event
Description
Description of the event. This is display only.
Event Filter
Report Event Check to report the event. This overrides the reporting value set for the
event Filter Group. For example, if the Filter Group Intruder Alarms is
set to report, you can exclude the BA event or by disabling this setting.
Filter Exception
Enable
Check to exclude a range of addresses, for example Zone IDs, from
the Report Event field setting.
if (0 ≤ Zone ID ≤
9999)
then Report
Event/Don't
Report Event
Enter a range of addresses to exclude from the Report Event setting.
For example, if you choose to report the event type BA, you may
choose not to report Zone ID 1 - 9 for that event.
Alternatively, if you choose not to report the event type BA, you may
choose to report Zone ID 1- 9 for that event.
Event Format
SIA Event Code Default SIA event code that is transmitted to represent the event. This
field is display only.
Contact ID Event
Code/Qualifier
Default Contact ID Event Code/Qualifier transmitted to represent the
event. This field is display only.
Remap
Exception
Enable
Check to remap the default SIA, CID code/Qualifier and Event Address
to customised values, for example, to remap Zone ID 1 - 9 to Zone ID
101 - 109. When enabled, the fields below display.
if (0 ≤ Zone ID ≤
9999)
Enter the range of addresses to remap for an event, for example, if you
want to remap Zone ID 1 - 9 to Zone ID 101 - 109, enter 1 and 9. The
quantity of addresses in the range must be equal to the quantity of
addresses defined in the field Remap Event Address below.
then Remap SIA
Event Code to
BA
Remap the default SIA code to a customised SIA code.
and Remap
Contact ID Event
Code/Qualifier to
Remap the default CID Event Code/Qualifier to a customised CID
Event Code/Qualifier.
and Remap
Event Address
to
Enter the new range of addresses, for example, if you are remapping
Zone ID 1 - 9 to Zone ID 101 - 109, enter 101 and 109.
2. Click Save.
3. Click Back to return to the Event Profiles page.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 234 I-200572
08.12.2023
To Next Page