Acre SPC42 - Page 8

21.2 Controller status LEDs 265
21.3 Powering expanders from the auxiliary power terminals 265
21.4 Calculating the battery power requirements 266
21.5 Domestic, Commercial and Financial mode default settings 267
21.6 SIA Codes 267
21.7 CID Codes 273
21.8 User PIN combinations 275
21.9 Duress PINs 275
21.10 Automatic inhibits 275
21.10.1 Zones 275
21.10.2 Access PINs 276
21.10.3 Engineer Access 276
21.10.4 Keypad User Logoff 276
21.11 Wiring of mains cable to the controller 276
21.12 Maintenance controller 276
21.13 Maintenance 277
21.14 Zone types 278
21.15 Zone attributes 283
21.16 ATS levels and attenuation specifications 285
21.17 Supported card readers and card formats 286
21.18 FlexC Glossary 288
21.19 FlexC Commands 289
21.20 ATS Category Timings 292
21.21 ATP Category Timings 293
22 Notes 295
SPC42/52/53/63 – Installation & Configuration Manual Table of Contents
© Vanderbilt 2023 8 I-200572
08.12.2023