Acre SPC42 - Page 96

To Next Page

To Previous Page

To upgrade the transceiver firmware to version 4.7.x, you must ensure that no more than 20 fobs

(remote controls or personal alarm buttons) are configured on your SPC system. If there are

more than 20 fobs configured, delete any excess fobs.

The combined maximum number of synchronous devices (wireless keypads and sirens) should

not exceed 16 per transceiver.

14.9.2.1 Add wireless sensor

Add a wireless sensor using a keypad:

1. Login as FULL ENGINEER.

2. On the keypad, select WIRELESS>SENSORS>ADD>ENROL.

The keypad displays the ADD screen with a flashing ENROL DEVICE message.

3. Open the detector.

4. Insert the battery taking care to observe correct polarity. Inserting the battery starts the

discovery process from the device.

The keypad displays the FOUND SENSOR message.

5. Click OK.

6. You can now enroll the device by configuring the AREA, ZONE TYPE and ZONE settings.

7. Click OK.

The keypad displays the UPDATED message.

The wireless sensor is now enrolled on your SPC system. Please note that the initialization delay

time can be up to 40 seconds.

14.9.2.2 Add wireless output

Add a wireless output using a keypad:

1. Login as FULL ENGINEER.

2. Select WIRELESS > OUTPUTS > ADD > ENROL to display the ADD screen with a flashing

ENROL DEVICE message.

3. Remove the cover.

4. Power up the output by inserting and connecting the battery. Connecting the battery starts the

discovery process.

5. When the discovery process succeeds, the keypad displays the FOUND OUTPUT screen with

the device ID, the output TYPE, and the SIGNAL level.

6. Click OK to confirm and to display the ADD screen.

7. Identify the output by entering a description (maximum 16 characters) and click OK to display

the BELL TYPE screen.

8. Select the BELLTYPE and click OK.

9. The keypad beeps twice and flashes the UPDATED message before returning to the

OUTPUTS screen.

The output is now enrolled on your SPC system.

Select EDIT to configure the VOLUME, AREA, and TAMPER OPTION settings.

SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the keypad

08.12.2023