6253 DC Voltage Current Source/Monitor Operation Manual
5.8.3 Remote Command List
5-31
5.8.3 Remote Command List
1. The Default column shows default settings at Power ON or at factory shipment.
• The Power ON column shows the status when the power is turned ON.
• The *RST or RINI command initializes the settings to factory default.
However, the RINI command cannot initialize *5 and the RINI or *RST command cannot
initialize *6.
2. Note for description in the command list
• Parameter enclosed in [ ] can be omitted.
• Parameters enclosed in < > are single delimited data items.
• The symbols in the Operation column shows the following:
in DC pulse OPR/SUS column:
Acceptable only in the HOLD trigger mode or in the Suspend status
in Sweep OPR/SUS column:
Acceptable only when sweep stops or in the Suspend status.
• : Acceptable only in the Suspend status.
To Next Page
Loading...
