ADCMT 6253 - Page 200

6253 DC Voltage Current Source/Monitor Operation Manual
5.8.3 Remote Command List
5-32
Item Command Description
Default Operation possibility
Power
ON
Factory
shipment
DC/pulse
OPR/SUS
Sweep
OPR/SUS
Source Source mode MD0 DC mode

MD1 Pulse mode
MD2 DC sweep mode
MD3 Pulse sweep mode
MD? Response: MD0 to MD3
Yes Yes
Source
function
VF Voltage source function
 Ye s
IF Current source function
Executing
this
function
sets
Suspend
Executing
this
function
sets
Suspend
V? Response: V0, V3 to V6 for VF
Yes Yes
I? I-2 to I4 for IF
Source range SVRX Optimal range
 Ye s No
SVR3 300 mV range
SVR4 3 V range
SVR0 10 V range
SVR5 30 V range
SVR6 100 V range
SVR? Response: SVRX0, SVRX3 to SVRX6 (for the
optimal range)
SVR0, SVR3 to SVR 6 (for the fixed
range)
Yes Yes
SIRX Optimal range
 Ye s No
SIR-2 3 A range
SIR-1 30 A range
SIR0 300 A range
SIR1 3 mA range
SIR2 30 mA range
SIR3 300 mA range
SIR4 2 A range
SIR? Response: SIRX-2 to SIRX4 (for the optimal range)
SIR-2 to SIR 4 (for the fixed range)
Yes Yes
Source value SOV data Voltage source value setting
0YesNo
SOI data Current source value setting
0
SOV? Response: SOVd.dddddEd
*1,*2
Yes Yes
SOI? SOId.dddddEd
*1,*2
*1: The decimal point position in response varies depending on the setting value.
For the source value, limit value, and time parameter setting ranges, refer to the specifications.
*2: Outputs the value that is currently generated or the value that is generated during Operate.