ADCMT 6253 - Page 201

6253 DC Voltage Current Source/Monitor Operation Manual
5.8.3 Remote Command List
5-33
Source Spot
command
G data Executes the measurement trigger after setting the
source value for the currently set source function.
Yes No
Limit value LMV
data1>
[, data2>]
Voltage limit value setting
110 V Yes
LMI
data1>
[, data2>]
Current limit value setting
2 A
Both the HI and LO limit values can be set.
• In comparison between data1 and data 2, the
larger value is the HI limit value and the smaller
one is the LO limit value.
• When data 2 is omitted, +data1 and –data 1 are
assumed as HI and LO limit values respectively
regardless of the data1 polarity.
LMV? Response: LMV<hl>, <ll>
*1
Yes Yes
LMI? LMI<hl>, <ll>
hl : <d.ddddEd> (High limit value)
ll : <d.ddddEd> (Low limit value)
Suspend
voltage
SUV data Suspend voltage setting
Setting range: 0 to 110 V
0Yes
SUV? Response: SUVd.dddddEd
*1
Yes Yes
Suspend
HiZ/LoZ
SUZ0 HiZ: High resistance output status
 Ye s
SUZ1 LoZ: Low resistance output status
SUZ? Response: SUZ0 or SUZ1
Yes Yes
Pulse base
value
DBV data Voltage pulse vase value
0YesNo
DBI data Current pulse base value
0
DBV? Response: DBVd.dddddEd
*1
Yes Yes
DBI? DBId.dddddEd
*1: The decimal point position in response varies depending on the setting value.
For the source value, limit value, and time parameter setting ranges, refer to the specifications.
Item Command Description
Default Operation possibility
Power
ON
Factory
shipment
DC/pulse
OPR/SUS
Sweep
OPR/SUS
NOTE:
1. LMI data1 and data 2 cannot be set
homopolar.
2. Set the difference between the HI and LO
limit values to 600 digits
(2000 digits in the 3  A range) or more.