6253 DC Voltage Current Source/Monitor Operation Manual
5.8.3 Remote Command List
5-48
Source Pulse base
value and
pulse sweep
base value
DB data
[UNIT]
The base value setting is different depending on
whether UNIT is specified or not.
With UNIT ... Automatically sets the optical
range.
Available unit:
UV,MV,V,UA,MA,A
Without UNIT ...Sets the present function and
range.
When setting a unit that is different from that of the
present source function, an error occurs.
For the pulse sweep mode, set the pulse sweep base
value.
0YesNo
DB? Response: DB<data>UNIT
data ...Voltage or current base value
<d.dddddE±d>
UNIT...V or A
The voltage or current base value is returned
depending on the currently set source function.
For the pulse sweep mode, the pulse sweep base
value is returned.
Yes Yes
Operate/
Standby
H Sets the output to OFF (Standby).
Yes Yes
E Sets the output to ON (Operate).
E?, H? Returns the present output status.
Response:
Yes Yes
Sweep Random
sweep
memory data
(using D
command)
N [adr]
P
Random sweep memory data setting starts from the
N command and completes at the P command.
N<adr>, D<data1><UNIT>,
D<data2><UNIT>, ..., P
adr: Memory address (0 to 19999)
data1: Voltage or current source value at adr
data2: Voltage or current source value at
adr+1
0
*6
Yes No
*6: Not initialized by the RINI or *RST command.
Item Command Description
Default Operation possibility
Power
ON
Factory
shipment
DC/pulse
OPR/SUS
Sweep
OPR/SUS
Status E?, H?
Operate E
Suspend H
Standby H
NOTE:
• When no source range is specified, the
optimal range is set.
• Source values different from the present
source function cannot be set.
To Next Page
