6253 DC Voltage Current Source/Monitor Operation Manual
A-5
404 Over Load Overload
405 Overload (when sourcing with reverse polarity)
801 Over Step 20000 < Number of sweep steps
802 Start > Stop Start value larger than stop value for log sweep
803 Start,Stop Polarity Different polarities between start value and stop value for log sweep
804 Start,Stop = 0 Start value or stop value = 0 for log sweep
811 Power Over Source or limit setting exceeding output range
822 Tp < Tds Timer condition error (Not Tp > Tds + 94 s) (Other than Burst)
823 Tp < Td Timer condition error (Not Tp > Td + 94 s) (Other than Burst)
824 Tp < Tds+Tw Timer condition error (Not Tp > Tds + Tw + 94 s) (Other than Burst)
825 Td < Tds Timer condition error (Not Td > Tds)
826 Tp < Td+Tm Timer condition error (Not Tp > Td+Tm (Tit+Tk)) (Burst)
827 Tp < Tds+Tw Timer condition error (Not Tp > Tds+Tw) (Burst)
828 Tp < 0.25ms Timer condition error (Not Tp > 250 s)
(Other than Burst and measurement ON)
829 Tp < 0.125ms Timer condition error (Not Tp > 250 s)
(Other than Burst and DC measurement ON)
831 Interlock Disabled by interlock
855 CAL data Calibration data error
-102 Cmd Syntax Command syntax error
-113 Cmd Undefine Command undefined
-200 Cmd Exec Execution error (Command currently not executable)
-222 Out of Range Input value out of setting range
150 USB error USB communication error
160 TCP error TCP communication error
170 RS-232 error RS-232 communication error
Table A-2 Error Message List (3 of 3)
Error
code
Message Description
To Next Page
Loading...
