6253 DC Voltage Current Source/Monitor Operation Manual
3.2.1 MENU Key (Parameter Setting)
3-14
Self Test Executes the self-test for selected items.
Select items with the rotary knob and press the ENTER key to
run.
1) Self Test Self test execution
2) LCD Pattern Display Display test
3) Key & Buzzer Test Key and buzzer test
Relay Count Displays relay operation count.
(Viewing only)
Serial No/REV Displays the serial number and software revision. (Viewing only)
LCD Off Turns OFF the display.
The EXIT key blinks while the display turns OFF.
Press the EXIT key to turn ON the display again.
PON Load Selects the parameter loading condition at power ON.
Power Off: Starts up using the setting parameters when the
power last turned OFF.
Load0: Starts up using the parameters saved in area 0 of
the non-volatile memory.
Error Log Displays the number of errors that occurred
Press the ENTER key to display the error log list.
Compati Mode Sets the 6243-compatible mode.
(Changing this setting will initialize the 6253.)
ON: Turns ON the 6243-compatible mode.
OFF: Turns OFF the 6243-compatible mode.
14) Graph Sets the system parameters.
Graph Displays the step numbers of the measurement data memory on
the horizontal axis and the measured values on the vertical axis.
Monitor-Measure Graph Displays the monitor value of the measurement data memory on
the horizontal axis and the measured values on the vertical axis.
To Next Page
Loading...
