COMMUNICATION AND VISUALIZATION TECHNOLOGIES
via Pastrengo, 7/C – 24068 Seriate (Bergamo)
Once the login procedure is complete, the code of the logged driver is reported on TC-430 main screen, as
in Figure 11.
Figure 11: Driver login feed-back
Driver logout can be performed by simply selecting the “Logout” function or selecting “Menu
Service menu
Logout”).
Driver credentials can also be supplied via USB key. In such a case the USB key must be prepared by using
Aesys® Verba 2014™ exporting the driver identification file (please refer to [1] for further details). Having the
USB key prepared, driver credentials are provided by connecting the USB key to the system. Driver logout in
that case is performed by simply removing the USB key from the system.
7.1.2 Data loading
A data file, specifying the archive of messages and the configuration of the system, has to be loaded into
TC-430™ before operating the control unit on the road.
The data file is produced by Aesys® Verba 2014™ (see [1] for further details about that) and can be either a
VDB or a TRX file (the former being the preferred choice and the latter supported just for backward
compatibility with old systems).
The data loading is started just connecting a USB key to the control unit. The screen in Figure 12 is shown.
Figure 12: Data file selection
To Next Page
Loading...
Need help?
General