COMMUNICATION AND VISUALIZATION TECHNOLOGIES
via Pastrengo, 7/C – 24068 Seriate (Bergamo)
Changes in repetitions count or interval are immediately applied (so there is no need to press any “Ok”
button): simply press “Back” for confirming settings and exiting menus.
9.6 Screens setup
9.6.1 Local override
The configuration of screen properties is usually defined by the data file being used by the system. In order
to perform local modifications to the configuration defined by the data file, the local override switch must be
enabled by accessing “Setup
Screens setup
Local override” (Figure 80).
Figure 88: Screens setup local override
Changes are immediately applied (so there is no need to press any “Ok” button): simply press “Back” for
confirming settings and exiting the menu.
9.6.2 Screens brightness
If screens local settings override is enabled (paragraph 9.6.1) then the brightness of screens can be
configured by accessing “Setup
Screens setup
Brightness” (Figure 89).
Figure 89: Screens brightness configuration
To Next Page
Loading...