Soft key labeled “Auto” toggles between automatic and manual mode.
In automatic mode screens automatically adjust their brightness depending on the detected environmental
light.
In manual mode the brightness percentage of all screens is configured by the slider shown in Figure 89 (soft
keys “-” and “+” can be used in order for respectively decreasing or increasing the brightness of screens).
Changes are immediately applied (so there is no need to press any “Ok” button): simply press “Back” for
confirming settings and exiting the menu.
9.6.3 Screens audio volume
The volume of screens can be configured by accessing “Setup
Screens setup
Volume” (Figure 90).
Figure 90: Screens audio volume configuration
Soft key labeled “Auto” toggles between automatic and manual mode.
In manual mode the volume percentage of all screens is configured by the slider shown in Figure 90 (soft
keys “-” and “+” can be used in order for respectively decreasing or increasing the volume of screens).
Changes are immediately applied (so there is no need to press any “Ok” button): simply press “Back” for
confirming settings and exiting the menu.
9.6.4 Media playlist switch
The screen at “Setup
Screens setup
Media playlist switch” (Figure 91) can be used for selecting which
is the source of the multimedia playlist to be reproduced by Aesys® on-board LCD/TFT screens connected
to the system.
Options are:
- Media: the multimedia playlist reports the media files manually selected by the bus driver (paragraph
7.1.6);
- CMS: the multimedia playlist is driven by the CMS channel currently configured on the system
(paragraph 9.8.7).
The selection can be toggled by tapping “Toggle” or the switch reported on the screen.
To Next Page
Loading...
Need help?
General