Figure 73: Toggling dash sign
Changes are immediately applied (so there is no need to press any “Ok” button): simply press “Back” for
confirming settings and exiting the menu.
9.4.6 Last publications
If signs local settings override is enabled (paragraph 9.4.1) then TC-430™ can be configured for
automatically reloading the last used destination, P/R message of info message upon reboot. Such
configurations are accessible (respectively) at “Setup
Displays setup
Last publications handling
Last
destination”, “Setup
Displays setup
Last publications handling
Last P/R message”, “Setup
Displays setup
Last publications handling
Last info message” (Figure 74).
Figure 74: Last publication flags
Changes are immediately applied (so there is no need to press any “Ok” button): simply press “Back” for
confirming settings and exiting the menu.
9.4.7 Diagnostics
Displays self-diagnostic can be toggled (enabled or disabled) depending on real capabilities of displays
available on-board the bus.
This feature is useful because on legacy Aesys® LED signs not supporting self-diagnostics protocol, sending
such commands may cause signs visualization troubles.
Displays self-diagnostic can be toggled accessing “Setup
Displays setup
Diagnostics” (Figure 75).
To Next Page
Loading...