COMMUNICATION AND VISUALIZATION TECHNOLOGIES
via Pastrengo, 7/C – 24068 Seriate (Bergamo)
Figure 30: Dash sign message selection
7.3 NextStop mode
While in NextStop, the TC-430™ is normally used for recognizing a given path or an entire service (a trip, a
roadmap or a workshift).
Figure 31 shows the main screen of TC-430™ while in NextStop mode: soft keys report the most important
functions offered by the active mode (all remaining functions can be accessed via “Menu” button).
Figure 31: “NextStop” main screen
Typical functions of Route/destination mode (see paragraph 7.2) are also accessible while in NextStop
mode, via “Dest”, “Inversion”, “Info”, “P/R” soft keys on main screen or via “Menu” button (for all other
functions).
7.3.1 Service selection
The service to be executed by the bus can be selected by choosing a workshift, a roadmap or a single trip
(please refer to [1] for further details about service definition) or a simple path.
A workshift is selected by pressing “WShift” or selecting “Menu
Service menu
Select workshift”. The list
of workshifts available in the current day is shown on screen (Figure 32).
To Next Page
Loading...