Note: The movement of the X-ray tube stand has a small delay
compared to the movement of the table. The movement of the X-
ray tube is automatically stopped if the distance between the X-
ray tube head and the table would become too small (SID lower
than 45 cm).
The lock button controls the behaviour of the position tracking after the
exposure is made.
Table 28: Locking the position tracking
Position tracking is not active for the next exposure. It can
be activated again by pressing the position tracking but-
ton.
Position tracking is kept active for the next exposure.
168 | DR 600 | Software Console and Tube Head Display
3261K EN 20210708 0808
To Next Page
Loading...
