Mounting the tabletop hand grips
The pair of tabletop hand grips are used by the operator for moving the
floating tabletop. Using the hand grips will avoid the operator grasping the
table edges which could cause a risk to pinch fingers.
To mount a hand grip:
1. Slide the hand grip in the rails of the tabletop.
2. Mount the stop blocks at the end of the rails to prevent the hand grip from
sliding out of the rail.
Figure 91: Hand grip
204 | DR 600 | Radiographic Table
3261K EN 20210708 0808
To Next Page
Loading...
