Configuration
DR 600 is a configurable DR (Direct Radiography X-ray system) and/or CR
(Computed Radiography) X-ray system.
DR 600 has configurations for DR, for CR and for mixed use of DR and CR.
DR 600 supports following applications:
• General radiography, including pediatrics
• Full leg full spine radiography
The complete DR 600 consists of the following components:
• Ceiling suspension with X-ray tube, collimator and tube head display
• Radiographic table with an integrated DX-D Fixed DR Detector or with a
bucky. In the bucky a DR Detector or a CR cassette can be inserted.
• Radiographic wall stand with an integrated DX-D Fixed DR Detector or
with a bucky. In the bucky a DR Detector or a CR cassette can be inserted.
• Bucky with integrated battery charger for DR 14s detecors (optional)
• X-ray generator
• X-ray generator mini console
• X-ray tube with collimator
• NX workstation
• DR Generator Sync
• Automatic Exposure Control (AEC)
• Dose Area Product Meter (DAP, optional)
• Remote control (optional)
• Collimator camera ( Smart XR upgrade mounting kit, optional)
Limited DR 600 configurations can consist of a ceiling suspension with only a
wall stand or only a radiographic table.
X-ray parameters are controlled using the Software Console on the NX
workstation.
The Software Console is available on the NX workstation, to synchronize the
X-ray exposure parameters between the NX application and the generator.
Depending on the configuration the following components are also available:
• Portable DR Detector
DR 600 can be used in combination with:
• DX-G
• DX-M
• CR 30-X (5175/2XX)
• CR 30-Xm
• CR 10-X
DR 600 | Introduction |
17
3261K EN 20210708 0808
To Next Page
Loading...
