Software Console
The Software Console is available to support X-ray exposure and position
parameter control on the NX workstation. It is displayed on the NX
workstation next to the NX application.
The Software Console is used to control the X-ray exposure settings.
The Software Console is used to adapt the parameters for automatic
positioning.
The Software Console contains the DR Detector Switch.
Figure 8: Software console controls for generator, X-ray modality, positioner,
tomosynthesis and system messages
Related Links
Software Console and Tube Head Display on page 124
Generator controls on page 142
X-ray modality controls on page 157
Positioning controls on page 158
Controls for digital tomosynthesis on page 173
System messages on page 178
DR 600 | Introduction | 29
3261K EN 20210708 0808
To Next Page
Loading...
